Speed and Width Negotiation: Inputs and Outputs

Inputs and outputs contract

Inputs and Outputs for Speed and Width Negotiation focuses on Negotiated link speed, active lane count, and downgrade event frequency. The purpose is to turn memory observations into mechanism-backed actions with explicit owners and release-safe validation.

Use this contract for architecture, controller firmware, PHY, and validation handoffs. Missing inputs create expensive late-stage rework and inconclusive debug loops.

INPUTS
  - workload distribution and QoS target
  - firmware revision, controller policy profile, timing registers
  - data-rate / voltage / temperature operating state
  - training snapshot and reliability policy status

OUTPUTS
  - bottleneck classification with command-level evidence
  - owner-signed mitigation proposal
  - before/after trend for latency, bandwidth, and reliability
  - regression matrix with rollback triggers

Ownership split

OWNERSHIP LAYERS - Speed and Width Negotiation

layer              owner
-----------------  ----------------
protocol/RTL       PHY owner
PHY/SI             PHY + SI/PI owner
firmware/OS        FW + driver owner
validation         compliance + post-silicon

PCIe/CXL deep dive

LTSSM and equalization determine whether high-speed links are stable under corner traffic and retimer paths.

Concept diagram

LTSSM + EQ

Detect -> Polling -> Config -> L0 <-> Recovery

Metric graph

LINK INSTABILITY SOURCES

EQ margin           ██████
retimer FW          ████
SI/cable plant      ███

Reports and artifacts

• LTSSM state log

• EQ coefficient dump

• negotiated speed/width snapshot

• recovery trigger timeline

Mini case study

Gen5 passed cold boot EQ but entered Recovery loops under DMA heat after retimer firmware update.

Debug branches

• Capture ordered sets at failure boundary

• Compare EQ presets across temperature corners

• Bypass retimer to isolate segment faults

Senior review question

Ask: which latency, bandwidth, and reliability evidence proves this PCIe/CXL topic is closed under real traffic?

Key takeaways

• Always tie controller and PHY counter shifts to application latency and throughput outcomes.

• Lock firmware timing profile, thermal condition, and DIMM state before comparing PCIe/CXL captures.

Common pitfalls

• Chasing peak bandwidth while ignoring p99 latency and fairness tails.

• Changing timing guardbands without separating SI noise from scheduling issues.

• Declaring closure without reliability gates, fault injection, and regression replay.

Handoff explanation

Inputs extend beyond timing registers. PCIe/CXL analysis inputs include traffic distribution, address map, queue policy, training state, SI/PI condition, thermal state, and firmware version.

Outputs must be action-ready: Negotiated link speed, active lane count, and downgrade event frequency, artifact packet (Link capability vs negotiated status register snapshot), bottleneck class, owner, expected gain, and rollback scope. "Bandwidth improved" without this packet is not signoff-ready.

The safest handoff is a before/after evidence set: environment tags, traces, hypothesis, chosen fix, rejected alternatives, and regression criteria.